1. Before starting vegetable cutting machine, please check whether there are objects in the barrel. If there are no objects, please install the round dustpan equipped with the machine to the food inlet, and install the two square dustpans (buckled together) to the outlet. Turn on the power, turn on the switch, put the vegetables after the motor runs normally, and it is strictly forbidden to start the load.
2. User selects a matching cutter according to his needs. Steps for installing the cutter: Loosen the butterfly nut, rotate the thickness adjustment handle toward the inlet, adjust to the thinnest position, the cutter blade is upward, install it on the knife holder, pay attention to push with one hand While holding the cutter, use your other hand to turn the two fixed knobs. When turning, do not turn one knob at a time to the end. This may squeeze the cutter and require the two knobs to be tightened gradually. After fixing, it is recommended to touch whether the tip of the cutter is beyond the blade edge of the slicer. If it exceeds a little bit, it is installed in place. Finally, rotate the handle to the desired thickness and tighten the butterfly nut.
3. How to slice , shred and Cube
(1) Only the slicing knife is installed, and the slice is the slice, and the slice with a thickness between 2mm-8mm can be obtained by adjusting the thickness and adjusting the handle. There will be some unevenness in the thickness of the sheet, which is determined by the principle of the machine.
(2) When the slicing knife and the wire cutter are installed at the same time, the wire comes out. The width of the wire is adjusted by replacing the wire cutter, and the thickness is adjusted by adjusting the handle.
(3) Cut the silk and put it into the barrel for processing once again.
4. After using the machine, please wipe the bucket clean with a damp cloth in time. Store in a ventilated and dry place.